Reservoirs for water features

For a truly professional approach to placing your natural rock water feature we recommend rock reservoirs. They are simple to install and no open water is shown when they are in place. covering the lid with pebbles acts as a natural filter so no debris can get in. These reservoirs are specifically designed to support the weight of natural rock water features. They can be placed above or below ground and installation is simple

Water Feature reservoirs are available in several sizes:

The Oase 600 ( 600 mm Diameter, 400mm deep) high water volume(64 litres) €139 complete with lid

The 650 ( 650 mm Diameter,. 300mm deep) (30 litres)€129 complete with lid

The EC 700 (700mm Diameter, 300mm deep,(60 litres)complete with lid €95

The 1000 ( 980 mm Diameter)(70 litres) €189 complete with lid
The Oase 1000 (1000mm diametre, 400mm deep)(138 litres) €299 complete with fibre glass lid capable of supporting 300 kilograms in weight
The 1800 ( 1800 mm Diameter, 360mm deep) and F.E.A tested to carry a 1 Tonne feature. €695 complete with lid capable of supporting 1000 kilograms in weight

Benefits

· Stable and freestanding, no open water , very safe· In or above ground use

· Direct pump access/hatch · Indoor or outdoor use

· Large water capacity · No sharp grills/bricks/pipes, no need for rusty metal grids

· Strong PE+ 100% recycled plastic · Supports an immense amount of weight

1.8m diameter reservoir suitable for large water features

TIPs

1. Size your reservoir according to your water feature size and shape.

600mm tall is maximum for the 650.

900mm tall is maximum for the 1000.

1700mm tall is maximum for the 1800.

2. A liner can also be used as a skirt around the reservoir to increase the catchment area of the water.

3. A ballcock can be added to the reservoir so that you never have to top it up.


	TYPICAL INSTALLATION DRAWING FOR A WATER FEATURE

The water simply recirculates from the pump, through the rock and back down into the reservoir to start again. No water supply is required. The lid of the reservoir is designed to take the weight of the rock. the lid has some very small holes to allow the water to flow back into the reservoir.

We do use lids that will rust over time and we do not use galvanized metal lids . All the reservoirs we supply are self supporting and can be used above ground or below. They are specifically designed to carry the weight of water features. The reservoir lid can hold any type of pebbles or stones you choose without the need for an extra mesh which would rust over time. All the lids have an access port for easy removal of pump.

This type of water feature is virtually maintenance free as the stones on top of the lid act as a filter stopping leaves and debris entering the water.

If the reservoir is left on the ground a wall or plants can be used to disguise the reservoir. Naturally the reservoir can be partly buried if required and many people do this to increase the height of there feature. For instance if you choose a water feature that is 300mm tall you can make it appear taller by not burying the reservoir at all. If you choose a wall to go around the reservoir you now have an ideal spot to sit, relax and watch your water feature.

Often people put the water feature in raised bed, this is another way of making the feature look taller as the raised bed may be 400mm or more of the ground and now when you put a water feature in the raised bed it to appears taller.

We always recommend that you put the water feature in a place that can be viewed from inside your home. Even on a dark night with the addition of a light you will be able to enjoy your water feature.

RockWorld WATER FEATURE SHOWROOMS OPEN MONDAY TO SATURDAY 10AM TO 5.30PM.

Allenwood, Co. Kildare, Ireland (see map & directions here)

Phone 045 870 970 International Phone 00 353 45 870 970 or Contact us