|
Installing a large water feature using a rock reservoir
Choosing the right place to site your water feature container is important, think about the backdrop, do you need space behind it to put pot plants?
Adding Low voltage lights can also produce a spectacular effect at night.
STEP 1
Make sure the hole is level and at the right depth can save a lot of time putting the reservoir in and out of the hole.
STEP 2
If the total weight of the feature exceeds 150 kg, think about soil structure, will it subside over time? If you think it will add a suitable concrete base, this will save you having to re-level at a future date. STEP 3
After smoothing out the concrete put the reservoir in and make sure it is level before the cement sets.
STEP 4
After the concrete has set, back fill around the reservoir base with soil. If the feature is over 250 kg soil can be pushed into the 'fins' for additional support. For really heavy features see the reservoir moulds section for 'concreting fins'.
STEP 5
The reservoir fins , for additional support being made of 100% recycled MDPE, are flexible and can be lifted to gain access to the pump for maintenance. STEP 6
When the lid is in place your chosen feature can be assembled on top. After positioning your chosen water feature turn on the pump and check the height of the water, if it too high the water will splash outside the reservoir and the pump will run dry quickly.
STEP 7
Make sure all electrical cables are adequately protected, connections are water proof and the whole electrical installation is safe. If in doubt consult a qualified electrician. Plant round the back of the feature and add decorative stones to to hide the remainder of the reservoir
|
